General Product Information

2.5mm thick

Suitable for walls with a minimum crushing strength of 3.5N/mm²

Load bearing surface (top flange) 76mm, 90mm bearing at base of shoe.

All hangers 150mm deep and over are made 10mm less to ensure joist levels are maintained.

Tested by Ceram Research, full test report available on request.

Material Specification: 44 and 50mm wide - 2.5mm Pre Galvanised Steel S280GD+Z275

all other sizes DX51D+Z275 (Available in Stainless Steel)

Also available in Stainless Steel

Installation:

The back plate of the hanger should lie flat against the vertical masonry support

Masonry flange should have a minimum of 3 courses (675mm masonry) above.

Both supporting and above masonry should be allowed to mature before any load is applied.

Joist should be square cut and sit tight to the back of the hanger - maximum gap permitted is 6mm.

Nail the side flanges with 30 x 3.75mm galvanised square twist nails or equivalent.

To provide lateral restraint HD Straps should be used.