General Product Information

Highly versatile for fixing timber to timber, masonry or concrete.

Tag on the base of the hanger helps avoid rotation, please specify the tag

required upon ordering as these can not be bent on site, eg HWT U 50.

If a tag is not specified at the time of order an NT will be supplied.

Nominal depth 150mm

The hanger should be a minimum of over half (60%) the depth of the supported member to avoid rotation.

SWL 13.75kN - Fully Nailed using 30 x 3.75 Sq Twist Nails.

SWL 18.5kN - Fully nailed and coach screwed using 3no. M10 x 75mm Coach Screws

on either side and the supported joist bolted through the hanger using an M12 Bolt

Safe working loads for Timber to masonry are dependant on the block strength

and fixings used, contact fixing manufacturer and TECO for full details.

Material Specification: 2.5mm Pre Galvanised Mild Steel to BS EN 10327:2004 DX51D+Z275

Also available in Stainless Steel

HWT I Hangers are available in widths of 90mm and above.